Neuron CNC » Products

Products

Neuron Software: Plugin for Mach3 / Mach4 / UCCNC

Neuron Software: Plugin for Mach3 / Mach4 / UCCNC

Plugin for Mach3 / Mach4 / UCCNC
Expansion board for Neuron Professional Torch Height Controller

Expansion board for Neuron Professional Torch Height Controller

This board is connected to the Neuron Professional controller for control the oxyfuel gas console valves (for oxyfuel cutting) or control sectional ventilation system.

$75

Neuron Ohmic sensor for Initial Height Sensing procedure. Compatible with high frequency start plasma system

Neuron Ohmic sensor for Initial Height Sensing procedure. Compatible with high frequency start plasma system

Ohmic sensing gives a low cost alternative to find the pierce height using an electrical contact of the torch cap to the plate, This results in a very accurate height with an extremely soft touch-off.This is the most helpful when cutting very thin materials that might flex under the pressure sensing (FloatHead) method of plate detection. Because the system does not measure the transfer height distance until the tip actually looses contact on the retract cycle, even the smallest deflection is eliminated from the height calculation. This is a simple install that takes only a few minutes to complete and may be used on any plasma system.

$95

Neuron Lite Torch Height Controller

Neuron Lite Torch Height Controller

This is the best solution for all plasma cutting table. Work with any plasma cutter.

$755

Neuron Professional Torch Height Controller

Neuron Professional Torch Height Controller

This is the best solution for all plasma or oxyfuel cutting table. In this version added relay outputs for Ventilation control and "Preflow in IHS", "PierceEnd" signals (can use with Oxygen plasma cutting system). You can use the optional expansion PCB for control the oxyfuel gas console valves (for oxyfuel cutting) or control sectional ventilation system.

$935

Neuron Simplicity Torch Height Controller

Neuron Simplicity Torch Height Controller

This is the best solution for any plasma cutting System. Works with any plasma cutters and any CNC (Mach3, Mach4, Linux EMC2 and other).

$469 (Standart CNC connection PCB)
$499 (Simplicity CNC BOB)